Electrical, Ignition & Data Systems

1-1/2" Pressure, 0-60 PSI, Mechanical, Silver

Features:• Perfect for installing in tight spaces• Great for monitoring air, fuel, or oil pressure• Utilizes 1/8" NPT male fitting on back of gauge for installation• Liquid dampened movement provides smooth pointer movement and extended service life in...

Firewall Feed-Thru

Use this Firewall Feed-Thru to route the spark plug wire through the firewall. Features:• 1/2" insulation so the coil's spark reaches the distributor• Prevents voltage leaksClick here to download the MSD-8211 Firewall Feed-Thru instructions.

EGT Cap, 1/4"

Cap for 1/4" EGT bungs.

Dual Battery Mount

Our  battery tray can be used to mount single or dual battery systems. The tray can either be bolted or welded into place. Includes batteryhold-down.Length:13-3/4" Width: 10-1/4"

Driveshaft RPM Sensor, 3-Pin, 5/16" dia.

This speed sensor is commonly used to detect Drive Shaft RPM or Wheel RPM. This metal sensor has a 5/16" fine thread pitch and is triggered using magnets. Works with the following Racepak data loggers and dashes:• Sportsman• IQ3 Drag• V300SD• V500SD

Driveshaft RPM Sensor, 2-Pin, 5/16" dia.

This speed sensor is commonly used to detect driveshaft RPM or wheel RPM. This plastic sensor has a 5/16" fine thread pitch and is triggered using magnets. Works with the following Racepak data loggers and dashes:• Pro 1B / Pro II• V300• V500

Double O Button

With the fully anodized black bracket and rim, and a oversized, red concave shaped top that measures close to the diameter of 1", this Double O Button looks great, and fits a finger perfect, with or without gloves. The bracket allows for easy mounting...

Single Channel Digital Ignition Tester

MSD Ignition Testers save you time by allowing you to test the ignition and coil without removing them from your car! With the MSD-8998, you can check the operation of MSD's single channel ignition controls. Features:• Generates a trigger signal to test...

Carbon Fiber Dash for RacePak Dash

Use this carbon dash to add a sleek finish around your digital RacePak Ultra Dash.  Quarter turn fastener bolt-in place to help hide the wires.

Digi-Set Timer

Used to change shock settings or activate a second stage of nitrous or nearly anything else that needs to be time activated. Can be set up to start using nearly any switch used during a run (ie gear shift, trans brake, clutch switch etc.).   Comes with...

Delay Box Flat Mount

This delay box mount is designed to mount the Mega 450 (or similar box) in any number of locations. Includes a 3/4" diameter pre-bent tube to make mounting an ease. Welding required. 

Delay Box Tube Mount

This delay box mount is designed to mount the Mega 450 (or similar box) in any number of locations. The two 18" long tubes (not shown) can be bent/formed to weld to a solid frame or cage member. Additional bracing is required to minimize vibrations...