Electrical, Ignition & Data Systems

On-Off-Test 2 Poles Toggle

Fuel pump switch on-off-test 2 pole toggle.

On-Off-On Pole Toggle

Cooling switch on-off-on 2 pole toggle.

On-Off 2 Pole Toggle

Ignition switch on-off 2 pole toggle.

On-Off 1 Pole Toggle

On-off single pole toggle.

O2 Sensor Stainlesss Weld-In Bung

When welded in place, this bung provides a place to mount O2 sensor.

O2 Bung Plug

This is a O2 sensor plug that you can use to plug your old O2 sensor bung if it not in use.

Non-Magnetic Pickup Assembly, 3/4" x 16 UNF

MSD’s Non-Magnetic Pick-Ups are engineered for extreme applications. This Pick-Up was designed and tested on 300+ mph top fuel dragsters! 

Nitrous Switch Panel Jumper Strip

Make wiring your nitrous QM switch panel a ease with this 1/8" copper jumper strip. The jumper strip ties all your switches together.

Programmable Digital-7 Plus Ignition

The Programmable Digital-7 Plus Ignition includes all of the standard programmable features such as Individual Cylinder Management, Step Retards, Rev Limits, and Shift Points. A MAP sensor is required for the boost circuit. The Ignition is supplied with...

Power Grid Harness Adapter, Power Grid Controller to Digital-7 Programmable

The Power Grid Harness Adapter allows you to use your Digital-7 Programmable to install a Power Grid Controller with very little alterations. The harnesses are direct plug-ins for existing wires, but will need two new wires to run if you desire to use...

Power Grid Replacement Harness

This Power Grid replacement wiring harness is designed for use with the MSD-7730 Power Grid Controller.

Power Grid Advanced RPM Control Module

This Advance RPM Control Module sets rpm limits based on rpm acceleration or time since launch. Features:• Plugs into CAN-Bus Bridge• Use with Power Grid Controller• 4-Connector CAN-Bus Hub is required Note: Please make sure your MSD-7730 Power Grid...