Electrical, Ignition & Data Systems

V-Net Tee Cable, 18"

Tee cables allow the user to "branch off" the main V-Net cable, to access V-Net sensors and modules that are out of reach of the main V-Net cable.V-Net modules and Interface modules, although similar in construction and appearance, are very different in...

Interface Extension Cable, 108"

For extending Analog and Interface Module connections on V300SD, V500SD and G2X Pro data loggers.V-Net modules and Interface modules, although similar in construction and appearance, are very different in the functions they perform. It is important that...

Remote Pressure Sensor, 75 PSI

The small size and ruggedness of these ‘PT-type’ pressure transducers make them ideal for the measurement of pressure directly at the source. The transducer requires 5 volt DC power and provides a .5 to 4.5 volt output signal. Each transducer mounts...

Remote Pressure Sensor, 300 PSI

The small size and ruggedness of these ‘PT-type’ pressure transducers make them ideal for the measurement of pressure directly at the source. The transducer requires 5 volt DC power and provides a .5 to 4.5 volt output signal. Each transducer mounts...

Smartwire Power Control Module

Based on Racepak’s exclusive single cable V-Net technology, the Racepak SmartWire module is the electronic “starting point”, with a direct main power connection from the vehicle battery to the module. Each input/output is then user defined, both in...

Master Disconnect Kit

This assembly allows all electrical power to be shut off for safety purposes. Features an easy and presentable inside installation. Complete with lever, hardware and 125 amp switch. (welding required)

QM Battery Mount

The Quarter-Max Battery Tray is a quick, economical way to mount a single battery. Weld the tray in place and bolt the battery in place with the included  hold-down. Length: 11" Width: 7" Height: 4"

Proximity Sensor

Magnetically triggered switch normally open and closed with magnet passage. Same as supplied with Racepack Computer Systems. Fits 3/8" diameter hole in mount bracket.

Pro Power Coil

The MSD Pro Power Coil is designed short duration applications such as drag racing. Features:• High voltage coil designed for short duration applications only• Primary and secondary windings are encased in Ciba polyurethane for vibration protection•...

PCT3-P Pro Cube Plus Delay Box with 3 Timers

SMALL IN SIZE – HUGE IN FEATURES PRO-DIAL DIAL BOARD OUTPUTS-- (2) Fiber optic outputs capable of of controlling TWO Pro-Dial dial boards. Automatically sends your dial-in to any of our Pro-Dial dial boards. No need for a separate controller...

Overhead Switch Panel

The RJ Overhead Switch Panel provides complete electrical control made from 5052 aluminum. Designed for easy overhead mounting and wiring. This panel has enough room for switches that it can be used to run nitrous systems. The box is fuseless, but with...

On-On Pole Toggle

Single pull double throw on/on toggle switch