Racepak & Data Systems

Interface Extension Cable, 108"

For extending Analog and Interface Module connections on V300SD, V500SD and G2X Pro data loggers.V-Net modules and Interface modules, although similar in construction and appearance, are very different in the functions they perform. It is important that...

Remote Pressure Sensor, 75 PSI

The small size and ruggedness of these ‘PT-type’ pressure transducers make them ideal for the measurement of pressure directly at the source. The transducer requires 5 volt DC power and provides a .5 to 4.5 volt output signal. Each transducer mounts...

Remote Pressure Sensor, 300 PSI

The small size and ruggedness of these ‘PT-type’ pressure transducers make them ideal for the measurement of pressure directly at the source. The transducer requires 5 volt DC power and provides a .5 to 4.5 volt output signal. Each transducer mounts...

Smartwire Power Control Module

Based on Racepak’s exclusive single cable V-Net technology, the Racepak SmartWire module is the electronic “starting point”, with a direct main power connection from the vehicle battery to the module. Each input/output is then user defined, both in...

Proximity Sensor

Magnetically triggered switch normally open and closed with magnet passage. Same as supplied with Racepack Computer Systems. Fits 3/8" diameter hole in mount bracket.

O2 Sensor Stainlesss Weld-In Bung

When welded in place, this bung provides a place to mount O2 sensor.

O2 Bung Plug

This is a O2 sensor plug that you can use to plug your old O2 sensor bung if it not in use.

V-Net Voltage Module, 0-5v Input, 5v Output

This V-Net module allows users to monitor any analog sensor (travel, pressure, etc.) that utilizes 5 volt power. This analog function module has been programmed for general usage, and has not been assigned to a specific task. Use of this module on the...

Driveshaft Sensor Mount Bracket

This driveshaft bracket allows you to fasten your Racepak driveshaft sensor to a 9" center section. Fits all 5/16" sensors and features slotted mount for easy adjustment.

EGT Cap, 1/4"

Cap for 1/4" EGT bungs.

Driveshaft RPM Sensor, 3-Pin, 5/16" dia.

This speed sensor is commonly used to detect Drive Shaft RPM or Wheel RPM. This metal sensor has a 5/16" fine thread pitch and is triggered using magnets. Works with the following Racepak data loggers and dashes:• Sportsman• IQ3 Drag• V300SD• V500SD

Driveshaft RPM Sensor, 2-Pin, 5/16" dia.

This speed sensor is commonly used to detect driveshaft RPM or wheel RPM. This plastic sensor has a 5/16" fine thread pitch and is triggered using magnets. Works with the following Racepak data loggers and dashes:• Pro 1B / Pro II• V300• V500