Racepak & Data Systems

V-Net to Smartwire Tee Cable, 18"

This cable allows users to connect a Smartwire to their V-Net sensors and/or data logger. This cable allows the SmartWire unit to share information from your Racepak V-Net system to further enhance the switching capabilities of your SmartWire setup...

Smartwire Switch Panel

Constructed from aluminum and black anodized for a professional appearance, the SmartWire Switch Panel is connected, via a single cable, to the Switch Panel connector located on top of the SmartWire housing. Adding a second Switch Panel is quick and...

Small Magnet

Replacement magnet used in the Racepak driveshaft collars. Also used in input shafts to register clutch RPM and on wheels to determine wheel RPM. Each magnet measures .25" OD x .20" in length. North end of magnet is painted yellow for easy identification.

Single Channel Air/Fuel Sensor Package

The Racepak AF-1 is a single channel air/fuel sensor package designed to be utilized with any of Racepak’s Vnet (canbus) series of data loggers. Engineered for the harsh conditions of the racing environment, the Racepak AF-1 package includes the...

Shock Travel Interface Module, RR, 48"

This Interface module allows users to connect shock travel sensors directly to the high speed analog port on the V300SD, V500SD and G2X Pro data loggers.Interface modules are another unique component of the V-series recorders. These black 7-pin modules...

Shock Travel Interface Module, RF, 38"

This Interface module allows users to connect shock travel sensors directly to the high speed analog port on the V300SD, V500SD and G2X Pro data loggers.Interface modules are another unique component of the V-series recorders. These black 7-pin modules...

Travel Sensor, 0-8"

These linear travel sensors are designed to monitor even the slightest amount of shock travel or tire shake. These sensors can also be used to determine throttle or clutch position.

Travel Sensor, 0-4"

These linear travel sensors are designed to monitor even the slightest amount of shock travel or tire shake. These sensors can also be used to determine throttle or clutch position.

Zero Crossing TDC Sensor, 3-Pin, 3/8" dia.

Zero Crossing TDC Sensor, 3-Pin 3/8" dia. This speed sensor is used to pick up Top Dead Center (TDC) on the front hub of the engine. It is designed specifically for use with MSD-style crank trigger wheel and magnets. It must be used with a RPM input...

SD Card Reader

SD / Micro SD USB Card reader. This permits the SD card to be read by a PC using the USB port rather than the SD card slot.

Single Wire Oil Pressure Sensor

This single-wire sensor is commonly used to pick up fluid temperatures on the IQ3 and UDX Street Dashes and the LDX. This sensor is designed to measure the temperature of fluids such as water or engine and transmission oil where the temperature does not...

Remote Pressure Sensor, 3000 PSI

The small size and ruggedness of these ‘PT-type’ pressure transducers make them ideal for the measurement of pressure directly at the source. The transducer requires 5 volt DC power and provides a .5 to 4.5 volt output signal. Each transducer mounts...