Electrical, Ignition & Data Systems

Digital 6AL Ignition Control

The 6AL Ignition Control wiring is routed out one end of the unit through a sealed and locking connector. This eases installation and keeps your wiring looking neat and clean. The built-in rev limiter of the 6AL is located right on top of the housing for...

IQ3 Gauge Panel

Our new IQ3 Guage Panel is intended for the use with no dash.  • Material: Mild SteelNote: This item must be modified to fit your application.

Holley EFI Coil Mount

Holley EFI Coil Mount• Material: 4130• Thickness: .060

Plug-In Transducer Module, Original Series, 300 PSI

The original series transducer modules provide a variety of inputs from pressure and temperature, to voltage and strain gauge readings. These transducers are designed to be used in conjunction with a V-Net transducer box (810-MB-8P) or the Pro Series...

Plug-In Transducer Module, Original Series, 200 PSI

The original series transducer modules provide a variety of inputs from pressure and temperature, to voltage and strain gauge readings. These transducers are designed to be used in conjunction with a V-Net transducer box (810-MB-8P) or the Pro Series...

USM Pressure Cable, 144"

  144" cable with TI-style pressure sensor connector installed. Allows easy connection from the Universal Sensor Module to Racepak remote pressure sensors.

V300SD/V500SD Harness, Power, RPM, Battery Ignition

RPM & Power harness for your V300/V300SD/V500/V500SD. This harness provides the necessary connections for:• Engine RPM• Driveshaft RPM• Clutch RPM• Record Button• Power Connects to the 'RPM' port of the data logger.

V-Net Pressure Module, 5v

V-Net Module Only, Pressure, 5 volt.This replacement V-Net module is used to monitor a variety of pressures. This is the same module as used with our analog and digital sensor/module combination assemblies. The difference here being that these modules do...

V-Net Event Marker Module, 12v

V-Net Module Only, Event Marker Input, Switch Closure, 12 Volt. This module allows you to monitor a 12 volt event, such as the release of a powered button. Not for use with a contact closure switch.

V-Net Four Channel Analog Module, 8-Pin

This V-Net adapter module allows users to monitor 4 analog inputs from a Racepak transducer box (PN: RAC-810-MB-08P).

Pressure V-Net Module with Sensor, 0-300 PSI

V-Net Module with Sensor, Pressure, 0-300 PSI. These module and sensor combinations are the same as our V-Net Modules with Sensors, Analog (Pre-Programmed) with the exception that they have not been pre-programmed. In other words they have not been...

Air Temperature V-Net Module with Sensor, 0-300°F

Temperature, Air, 0-300°F.This V-Net module allows you to measure air temperature, 0-300°F. Comes with a 72” lead. For a function to be monitored on the V-Net the signal from that function must pass through two components, a sensor and a module. The...