Strange Engineering

Lightweight 10" Slotted Steel Rotor, Fits Spindle Mount Wheels Requiring 1-1/2" Offset - RH Side

ApplicationStrange Aluminum StrutsUsing 2 or 3 piece Spindle Mount wheels – Right Hand Side NoteFits some early hub mount front brake kits produced before 1980 Supplied in Strange Brake kit B4598WC...

Load Bolt Assembly for Strange Ultra Case & HD Pro Aluminum Case

ApplicationStrange Ultra Case and HD Pro Case BenefitThe load bolt offers additional support during extreme conditions such as tire shakeThe steel tip is initially adjusted very close to the backside...

Low Friction Double Row Ball Bearing for Strange 2-Piece Pro Stock Axles

Double Row Ball Bearing– Large 3.543″ OD / 1.968″ ID bearing provides increased load capacity– Design allows for articulation between the inner and outer race– Ball bearing offers less friction than...

Lower Control Arm Kit, Ultra & Altered Ultra Struts - 1/2" ID Rod Ends

ApplicationUltra StrutsAltered Ultra Struts DescriptionLower Control Arm KitFor frame tabs using 1/2″ boltsProvides parts necessary to fabricate lower control arms Kit Includes4130 Chrome Moly Rear...

Master Cylinder Adapter Fitting, 1/2"-20 Inverted Flare to 3 AN

ApplicationStrange B3359 / B3359TA / B3360 / B3360TA master cylindersOEM Mopar K car master cylinder and aftermarket replacements Allows use of 3 AN brake lines common to Drag Racing For 9/16″-20 to...

Master Cylinder Cap

This Master Cylinder Cap fits Strange Engineering master cylinders. Must be used in conjunction with STR-B3362PA Master Cylinder Diaphragm.

Master Cylinder Diaphragm

This Master Cylinder Diaphragm fits with the STR-B3362P Master Cylinder Cap. These items fit Strange Engineering master cylinders. Must be used in conjunction with STR-B3362P Master Cylinder Cap.

Master Cylinder Reservoir Kit

Designed Specifically For Drag Racing3AN brake lines and fittings are not DOT approved • Fluid maintenance becomes more accessible• Allows mounting above brake caliper level• Eliminates the need for...

Mopar Housing Ends

DescriptionStrange Housing EndsSold as pair Features• 1026 billet steel• Butt weld design• For 3″ or 3 1/4″ OD tubing• Black oxide finish• Designed & machined by Strange• Material forged in the USA...

Olds Drilled & Tapped Housing Ends

DescriptionStrange Housing EndsSold as pair Requires O-Ring Style Axle Bearings Features• 1026 billet steel• Butt weld design• For 3″ or 3 1/4″ OD tubing• Designed & machined by Strange• Material...

Olds Housing Ends

DescriptionStrange Housing EndsSold as pair Requires O-Ring Style Axle Bearings Features• 8620 forged chrome moly steel• Butt weld design• For 3″ or 3 1/4″ OD tubing• Black oxide finish• Designed &...

Pinion Support Bearing Kit for Use with 28 Spline Pinion Shaft

Kit for N1922 / N2322 supports using 28 spline pinion ApplicationStrange pinion supports N1922 / N2322Using a 28 spline pinion shaft Using a 35 spline pinion shaft? – See N1924 Kit IncludesTimken®...