MSD Ignition

GM HEI Distributor Cap & Rotor, Red

Replacement cap and rotor for GM HEI The cap and rotor of any ignition system must be considered mainte­nance items. Just as you change the oil and filter of your car, you should always replace the cap and rotor as a set.

GM HEI Distributor Cap, Red

Red, stock GM HEI distributor cap. Features:• Stock GM HEI replacement distributor capClick here to download the MSD-8411 GM HEI Distributor Cap instructions.

Distributor Cap & Rotor, GM External Coil

The cap and rotor of any ignition system must be considered maintenance items. Just as you change the oil and filter of your car, you should always replace the cap and rotor as a set. Features: • Fits stock distributor

Mitsubishi Dodge Coil, 1996-ON

Bolt-on performance with increased output for your Mitsubishi/Neon/Talon/Mini MSD offers these two 4-tower coils as replacements for a variety of years ranging from 1994-2003 on vehicles including Mitsubishis, Neons and oth­ers. Note: Some OE coils use...

Coil Ballast Resistor 0.8 OHM

For use with an MSD Blaster Coil when connected to a stock points ignition system. The ballast is not necessary if an MSD 6 or 7-series Ignition Control is being used with the points distributor. Features:• Use with older points style ignitions

Dual Plug Wire Separator Kit, 8 - 8.5 mm

Not only do separators have to keep spark plug wires away from engine heat sources, they also have to keep the plug wires far enough apart to prevent inductive crossfire and actual spark loss. Features:• No tools needed• Stand alone or can be bolted...

Timing Tapes for Harmonic Balancers

Accurate ignition timing is one of the most vital adjustments you can make to your engine. Proper timing can mean the difference between winning and losing a race or even blowing an engine (as a worst case scenario). Recognizing the importance of the...

Super Conductor Spark Plug Wire Set, Multi-Angle Plug, HEI Cap

Routing spark plug wires is an art form. It takes patience and time to route your wires away from the headers, through separators and to the distributor cap. Some wire sets fit perfect, but a lot of people want to build their own so they can route them...

Pro Clamp Wire Separators

The Pro-Clamp will keep the plug wires in a tidy order and away from engine heat sources. Each separator features secure grooves for each wire and a top bracket snaps in place to sandwich the wires in place. Each base has a hole for a retaining screw if...

Connector Kit, 2-Pin

MSD’s Two Pin Connector Kit replaces damaged connectors or aids in custom wiring. Each kit comes with two connectors and four pins.This is the same connector used on MSD’s magnetic pick-up harnesses.

9000 Series Module Kit, Even Increments

RPM Module Kits include five modules in 200 rpm increments. Each kit is within a 1,000 rpm range.

7000 Series Module Kit, Even Increments

RPM Module Kits include five modules in 200 rpm increments. Each kit is within a 1,000 rpm range.