MSD Ignition

Shielded Magnetic Pick-Up Cable, 6'

This Shielded Magnetic Pick-Up Cable will help protect the trigger signal from the distributor or crank trigger pick-up from Electro Magnetic Interference. The pick-up wires are wound together and routed through a special aluminum skinned sleeve that...

RPM Activated Switch

This RPM-Activated Switch will perform a variety of different functions from turning on a bulb or solenoid to activating an MSD Timing Control at a desired rpm.The RPM-Activated Switch, has two activation wires; one to ground a circuit and the other to...

Pro Power Coil

The MSD Pro Power Coil is designed short duration applications such as drag racing. Features:• High voltage coil designed for short duration applications only• Primary and secondary windings are encased in Ciba polyurethane for vibration protection•...

Non-Magnetic Pickup Assembly, 3/4" x 16 UNF

MSD’s Non-Magnetic Pick-Ups are engineered for extreme applications. This Pick-Up was designed and tested on 300+ mph top fuel dragsters! 

Programmable Digital-7 Plus Ignition

The Programmable Digital-7 Plus Ignition includes all of the standard programmable features such as Individual Cylinder Management, Step Retards, Rev Limits, and Shift Points. A MAP sensor is required for the boost circuit. The Ignition is supplied with...

Power Grid Harness Adapter, Power Grid Controller to Digital-7 Programmable

The Power Grid Harness Adapter allows you to use your Digital-7 Programmable to install a Power Grid Controller with very little alterations. The harnesses are direct plug-ins for existing wires, but will need two new wires to run if you desire to use...

Power Grid Replacement Harness

This Power Grid replacement wiring harness is designed for use with the MSD-7730 Power Grid Controller.

Power Grid Advanced RPM Control Module

This Advance RPM Control Module sets rpm limits based on rpm acceleration or time since launch. Features:• Plugs into CAN-Bus Bridge• Use with Power Grid Controller• 4-Connector CAN-Bus Hub is required Note: Please make sure your MSD-7730 Power Grid...

Power Grid System, Controller Only

The Power Grid Ignition System is the next evolution of our Programmable 7-Series Ignition Controls. The Grid incorporates an efficient 32 bit microcontroller and an all new software program, called MSD View, and is USB compatible. The Windows based...

7AL-3 Ignition Control

The 7AL-3 allows you to make adjustments any time you want. It packs high voltage with four step retards, three rev limits and an rpm switch. All of the features are adjusted using plug-in modules including the 3-Step Rev Control and Multi-Step Retard...

7AL-2 Plus Ignition Control

You’ll recognize the 7AL-2 Plus Ignition Control, as its predecessor is the most popular ignition control used in drag racing. The “Plus” model updates the original 7AL-2 with improved internal components with an added a 2-Step Rev Control and diagnostic...

Launch Rev Limiter Switch Box

This Launch Rev Limiter Switch Box, also known as a Manual Launch Control, lets you change the launch rpm setting of the MSD-7531 Programmable Digital-7 Plus Ignition Control when you are in the car. Features:• Instantly changes the launch RPM setting of...