Chassis & Suspension

Rear End Housing Wishbone Mount

This laser cut bracket is used to mount wishbone to the housing must be bent in the desired area.

Rear End Housing Wishbone Mount Support Gusset

Wishbone mount   Material 0.125" 4130.

Wishbone Rear End Housing Mount Kit, Lower

This wishbone housing mount kit typically welds to the bottom of the rear end housing to mount the wishbone slide tube rod end. Features high misalignment bushing design. Installed on every Pro Housing built at Quarter-Max.

Wheelie Bar Wheel, Steel

Wheelie Bar WheelSpecifications:• Material: Steel• Hub width: 1-5/8"Sold each.

Wheelie Bar Wheel, Aluminum

Wheelie Bar WheelSpecifications:• Material: Aluminum• Hub width: 1-5/8"Sold each. DEEP DISCOUNT ON IN STOCK INVENTORY ONLY! LIMITED QUANTITIES AVAILABLE - ONCE THEY ARE GONE - THE DISCOUNT IS GONE TOO! All clearance item sales are final. Non-returnable.

Wheelie Bar Support Kit, 1-1/4 In. Tube Size

This Wheelie Bar Support Kit ties the upper and lower wheelie bar tubes together for added strength and less flexibility. Recommended for extremely high horsepower applications such as Pro Modified, and also recommended to add strength to longer wheelie...

Wheelie Bar Top Tube Support Bar

Wheelie Bar Top Tube Support BarSpecifications:• Thickness: 1/2"• Material: 6061-T6 aluminum

Wheelie Bar Load Cell with 1/2" Hole x 3/4"-16 Thread, 4130

Exclusive QM Wheelie Bar Load Cell designed to be stronger than any other load cell on the market. Relay the amount of force applied on your wheelie bars to your Racepak with this load cell. Fill the load cell with brake fluid and install the sensor into...

Wheelie Bar Load Cell, 5/8"-18 Female x 3/4"-16 Male, 4130

Relay the amount of force applied on your wheelie bars to your Racepak with this load cell. Fill the load cell with brake fluid and install the sensor into the 1/8" NPT port. Modification of current top wheelie bar tubes required to install, or switch to...

Wheelie Bar Load Cell

Used for measuring the load pressure on the wheelie bars during launch. Requires V-Net Module and Sensor. 5/8" shank.

Wheelie Bar Bracket

Wheelie Bar BracketSpecifications:• Thickness: 1/8"• Material: 4130

80 in. Pro Series Wheelie Bar Kit

Our Pro Series Wheelie Bars are made from 1-1/4 in. OD x .065  in. wall 4130 top bars and cross tube, and 1-1/8 in. OD x .058 in. wall diagonals. They feature a full "x" design brace for the lower section. Wheel housings come jig-welded to the lower...