Switches

Starter Button-Toggle Switch Low Profile Wrench

This thin wrench is designed to tighten the jam nuts on starter buttons and toggle switches. If you would use a standard wrench to try to tighten these jam nuts they are normally to thick to fit in the available space so we made this wrench just for this...

Starter Button Mount

Starter buttonMaterial 0.1825 4130   Hole size .2650"

Start Button Mount

Start button mount Material .125" 4130

Start Button Bracket

Start button Bracket base Material 14 gauge mild steel.

Short Jumper Switch Bracket

.062" Copper Sheet Hole sizes .190"

Remote Starter Button Mount

Easily mount your remote starter switches to the firewall or chassis and protect them from accidental engagement at the same time!(welding required)

On-On Pole Toggle

Single pull double throw on/on toggle switch

On-Off-Test 2 Poles Toggle

Fuel pump switch on-off-test 2 pole toggle.

On-Off-On Pole Toggle

Cooling switch on-off-on 2 pole toggle.

On-Off 2 Pole Toggle

Ignition switch on-off 2 pole toggle.

On-Off 1 Pole Toggle

On-off single pole toggle.

Clutch Switch with Adjustable Arm

This roll switch is typically mounted behind the clutch pedal and is commonly used to activate an ignition two step RPM switch, delay timer, or nitrous system accessories. Features a 9’ long four wire harness and adjustable swing arm with rolling wheel...