Ignition Modules & Accessories

Power Grid 4-Connector Hub - Black

This Power Grid 4-Connector Hub will allow users of the Power Grid System to connect up to four MSD accessory modules. • Also known as a 4-Connector CAN-Bus Hub• Intended for use with MSD Power Grid System only• BlackClick here to download the MSD-7740...

Timing Tapes for Harmonic Balancers

Accurate ignition timing is one of the most vital adjustments you can make to your engine. Proper timing can mean the difference between winning and losing a race or even blowing an engine (as a worst case scenario). Recognizing the importance of the...

Timing Pro Timing Light, Inductive

This MSD Timing Light is perfect for working in a garage, outside in the sun, or anywhere else you need to check your timing. The light provides stable, reliable signals from 0 to 10,000 rpm. The patented flash, makes it easy to see your timing scale by...

Self-Powered Timing Light

An accurate timing light is extremely important to the performance of your engine. This Self-Powered Timing Light does not require 12 volts. This means less wires are hanging over the engine compartment and makes for quick, easy checks. For power, the...

Tach/Fuel Adapter

Use this Tach Adapter if you are using the magnetic pickup input (green and violet wires) to trigger your MSD Ignition. It will correct the operation of most voltage-triggered tachometers that do not work directly off the tach output terminal of the MSD...

Timing Light Mount

Mount to firewall and use for power supply for your timing light.

Spark Plug Wire Sync Kit

This Spark Plug Wire Sync Kit installs to the number one spark plug wire and senses the trigger signal and sends this information to the Ignition through a fiber optic cable. Features:• For cylinder per cylinder managementClick here to download the...

Power Grid Harness Adapter, Power Grid Controller to Digital-7 Programmable

The Power Grid Harness Adapter allows you to use your Digital-7 Programmable to install a Power Grid Controller with very little alterations. The harnesses are direct plug-ins for existing wires, but will need two new wires to run if you desire to use...

Power Grid Replacement Harness

This Power Grid replacement wiring harness is designed for use with the MSD-7730 Power Grid Controller.

Power Grid Advanced RPM Control Module

This Advance RPM Control Module sets rpm limits based on rpm acceleration or time since launch. Features:• Plugs into CAN-Bus Bridge• Use with Power Grid Controller• 4-Connector CAN-Bus Hub is required Note: Please make sure your MSD-7730 Power Grid...

Launch Rev Limiter Switch Box

This Launch Rev Limiter Switch Box, also known as a Manual Launch Control, lets you change the launch rpm setting of the MSD-7531 Programmable Digital-7 Plus Ignition Control when you are in the car. Features:• Instantly changes the launch RPM setting of...

Single Channel Digital Ignition Tester

MSD Ignition Testers save you time by allowing you to test the ignition and coil without removing them from your car! With the MSD-8998, you can check the operation of MSD's single channel ignition controls. Features:• Generates a trigger signal to test...